Login
Register
Reset Password
Publish & Distribute
Publishing Solutions
Distribution Solutions
Subjects
Publications
Journals
Books
Proceedings
Publishers
Blog
Contact
Search
Cart
EUR
USD
GBP
English
English
Deutsch
Polski
Español
Français
Italiano
Home
Journals
Strojnícky časopis - Journal of Mechanical Engineering
Volume 70 (2020): Issue 1 (April 2020)
Open Access
Effect of Machine Feed Rate on Kerf-Width, Material Removal Rate, and Surface Roughness in Machining of Al/SiC Composite Material with Wire Electrical Discharge Machine
Manoj Modi
Manoj Modi
,
Gopal Agarwal
Gopal Agarwal
,
Swati D Chaugaonkar
Swati D Chaugaonkar
,
Umesh Bhatia
Umesh Bhatia
and
Veerendra Patil
Veerendra Patil
| May 13, 2020
Strojnícky časopis - Journal of Mechanical Engineering
Volume 70 (2020): Issue 1 (April 2020)
About this article
Previous Article
Next Article
Abstract
References
Authors
Articles in this Issue
Preview
PDF
Cite
Share
Published Online:
May 13, 2020
Page range:
81 - 88
DOI:
https://doi.org/10.2478/scjme-2020-0008
Keywords
Wire Electrical Discharge Machine
,
Kerf-width
,
Material removal rate
,
Surface roughness
,
Machine feed rate
,
Al/SiC composite material etc
© 2020 Manoj Modi et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.
Manoj Modi
Department of Mechanical Engineering, Acropolis Institute of Technology and Research
Indore, India
Gopal Agarwal
Department of Mechanical Engineering, Malaviya National Institute of Technology
Jaipur, India
Swati D Chaugaonkar
Department of Mechanical Engineering, Shri Govindram Seksaria Institute of Technology and Science
Indore, India
Umesh Bhatia
Department of Mechanical Engineering, Acropolis Institute of Technology and Research
Indore, India
Veerendra Patil
Department of Mechanical Engineering, Acropolis Institute of Technology and Research
Indore, India