<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The impact of machine feed rates of Wire Electric Discharge Machining on the kerf-width (K-width), material-removal-rate (MR-R), and surface-roughness (S-R) in the machining of Al/SiC composite is practically analysed. The relation among the feed rates of machine and K-width, MR-R, S-R is graphically acquired. It is demonstrated that lesser rate of feed is responsible for generation of larger K-width, lesser MR-R, and good finish as compared to more feed rate.</p></abstract>

The impact of machine feed rates of Wire Electric Discharge Machining on the kerf-width (K-width), material-removal-rate (MR-R), and surface-roughness (S-R) in the machining of Al/SiC composite is practically analysed. The relation among the feed rates of machine and K-width, MR-R, S-R is graphically acquired. It is demonstrated that lesser rate of feed is responsible for generation of larger K-width, lesser MR-R, and good finish as compared to more feed rate.

Effect of Machine Feed Rate on Kerf-Width, Material Removal Rate, and Surface Roughness in Machining of Al/SiC Composite Material with Wire Electrical Discharge Machine

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The impact of machine feed rates of Wire Electric Discharge Machining on the kerf-width (K-width), material-removal-rate (MR-R), and surface-roughness (S-R) in...

Effect of Machine Feed Rate on Kerf-Width, Material Removal Rate, and Surface Roughness in Machining of Al/SiC Composite Material with Wire Electrical Discharge Machine

Published Online: May 13, 2020

Page range: 81 - 88

DOI: https://doi.org/10.2478/scjme-2020-0008

Keywords
Wire Electrical Discharge Machine, Kerf-width, Material removal rate, Surface roughness, Machine feed rate, Al/SiC composite material etc

© 2020 Manoj Modi et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Effect of Machine Feed Rate on Kerf-Width, Material Removal Rate, and Surface Roughness in Machining of Al/SiC Composite Material with Wire Electrical Discharge Machine

Published Online: May 13, 2020

Page range: 81 - 88

DOI: https://doi.org/10.2478/scjme-2020-0008

KeywordsWire Electrical Discharge Machine, Kerf-width, Material removal rate, Surface roughness, Machine feed rate, Al/SiC composite material etc

© 2020 Manoj Modi et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
Wire Electrical Discharge Machine, Kerf-width, Material removal rate, Surface roughness, Machine feed rate, Al/SiC composite material etc