<abstract xmlns="http://www.w3.org/1999/xhtml"> The aim of the ongoing research is (i) to develop a new biodegradation landfill technique so that the landfill gas production could be controlled and the utilisation of the landfill gas could economically be optimized, (ii) to plan the energy utilisation of the landfill including individual and combined solutions (solar, wind, geothermal energy, energy storage using methanol etc.). [1, 2, 3] After summarizing the previous measurements made on the ongoing research, the first results of the oedometer tests are presented. The compression curves were determined, the measured data are evaluated by two simple models, the parameters are identified, the reliability of the parameters is tested. The simple models make possible the separation of the three major components of the settlement: the immediate settlement, the creep settlement and the primary consolidation settlement. The degradation induced strains were not considered since the tests were short term. Using these components, three different oedometric moduli are defined. The identified parameters are presented and compared with the parameters previously identified from some CPTu dissipation test data, and with the parameters measured by some recent seismic tests. The parameters are used to estimate the settlement of the landfill.</abstract>

The aim of the ongoing research is (i) to develop a new biodegradation landfill technique so that the landfill gas production could be controlled and the utilisation of the landfill gas could economically be optimized, (ii) to plan the energy utilisation of the landfill including individual and combined solutions (solar, wind, geothermal energy, energy storage using methanol etc.). [1, 2, 3] After summarizing the previous measurements made on the ongoing research, the first results of the oedometer tests are presented. The compression curves were determined, the measured data are evaluated by two simple models, the parameters are identified, the reliability of the parameters is tested. The simple models make possible the separation of the three major components of the settlement: the immediate settlement, the creep settlement and the primary consolidation settlement. The degradation induced strains were not considered since the tests were short term. Using these components, three different oedometric moduli are defined. The identified parameters are presented and compared with the parameters previously identified from some CPTu dissipation test data, and with the parameters measured by some recent seismic tests. The parameters are used to estimate the settlement of the landfill.

Evaluation of the Oedometer Tests of Municipal Landfill Waste Material

Institute of Civil Engineering, Ybl Miklós Faculty of Architecture and Civil Engineering, Szent István University, Budapest, Hungary

YBL Journal of Built Environment

This article is distributed under the terms of the Creative Commons Attribution Non-Commercial License, which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

{"article-title":"Evaluation of the Oedometer Tests of Municipal Landfill Waste Material"}

The aim of the ongoing research is (i) to develop a new biodegradation landfill technique so that the landfill gas production could be controlled and the...

Evaluation of the Oedometer Tests of Municipal Landfill Waste Material

Data publikacji: 10 lip 2014

Zakres stron: 42 - 64

DOI: https://doi.org/10.2478/jbe-2014-0004

Słowa kluczowe
landfill, waste material, waste sample, oedometer test, modelling, inverse problem solution, biodegradation.

© 2014

This article is distributed under the terms of the Creative Commons Attribution Non-Commercial License, which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

Evaluation of the Oedometer Tests of Municipal Landfill Waste Material

Data publikacji: 10 lip 2014

Zakres stron: 42 - 64

DOI: https://doi.org/10.2478/jbe-2014-0004

Słowa kluczowelandfill, waste material, waste sample, oedometer test, modelling, inverse problem solution, biodegradation.

© 2014

This article is distributed under the terms of the Creative Commons Attribution Non-Commercial License, which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

Słowa kluczowe
landfill, waste material, waste sample, oedometer test, modelling, inverse problem solution, biodegradation.