<abstract xmlns="http://www.w3.org/1999/xhtml">In this study, the simulation results of four vertical flow wetland systems using the HYDRUS Wetland Module are presented. The four wetland systems comprise three single-stage pilot scale systems and one full-scale two-stage system. The main difference between these systems is the filter media used, referred to as fine media, i.e., sand with a grain size distribution 0.063–4 mm, or coarse media, i.e., sand with grain size distributions between 1–4 mm, respectively. The water-flow simulation of each system is carried out using the single porosity van Genuchten-Mualem model. A good match between measured and simulated volumetric effluent flow rates could be achieved for all wetland systems. For reactive transport simulations, the CW2D biokinetic model was applied. First, simulations were run using the standard CW2D parameter set. For some systems, adjustments of the parameter set were needed in order to avoid unlimited bacteria growth. To better fit measured COD, NH4-N, and NO3-N effluent concentrations, adjustments of few parameters of the standard parameter set were required. The results show that for the VF wetlands with fine sand, no adjustments of the CW2D standard parameter set were needed, while for systems with coarser filter media as the main layer, the standard parameter set had to be adjusted to match simulated and measured effluent concentrations.</abstract>

In this study, the simulation results of four vertical flow wetland systems using the HYDRUS Wetland Module are presented. The four wetland systems comprise three single-stage pilot scale systems and one full-scale two-stage system. The main difference between these systems is the filter media used, referred to as fine media, i.e., sand with a grain size distribution 0.063–4 mm, or coarse media, i.e., sand with grain size distributions between 1–4 mm, respectively. The water-flow simulation of each system is carried out using the single porosity van Genuchten-Mualem model. A good match between measured and simulated volumetric effluent flow rates could be achieved for all wetland systems. For reactive transport simulations, the CW2D biokinetic model was applied. First, simulations were run using the standard CW2D parameter set. For some systems, adjustments of the parameter set were needed in order to avoid unlimited bacteria growth. To better fit measured COD, NH4-N, and NO3-N effluent concentrations, adjustments of few parameters of the standard parameter set were required. The results show that for the VF wetlands with fine sand, no adjustments of the CW2D standard parameter set were needed, while for systems with coarser filter media as the main layer, the standard parameter set had to be adjusted to match simulated and measured effluent concentrations.

Simulating vertical flow wetlands using filter media with different grain sizes with the HYDRUS Wetland Module

Institute of Sanitary Engineering and Water Pollution Control

University of Natural Resources and Life Sciences Vienna (BOKU)

Journal of Hydrology and Hydromechanics

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In this study, the simulation results of four vertical flow wetland systems using the HYDRUS Wetland Module are presented. The four wetland systems comprise...

Simulating vertical flow wetlands using filter media with different grain sizes with the HYDRUS Wetland Module

Data publikacji: 06 lut 2018

Zakres stron: 227 - 231

Otrzymano: 29 cze 2017

Przyjęty: 07 wrz 2017

DOI: https://doi.org/10.1515/johh-2017-0053

Słowa kluczowe
Treatment wetlands, Vertical flow, French VF wetland, HYDRUS Wetland Module, CW2D

© 2018 Bernhard Pucher et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Simulating vertical flow wetlands using filter media with different grain sizes with the HYDRUS Wetland Module

Data publikacji: 06 lut 2018

Zakres stron: 227 - 231

Otrzymano: 29 cze 2017

Przyjęty: 07 wrz 2017

DOI: https://doi.org/10.1515/johh-2017-0053

Słowa kluczoweTreatment wetlands, Vertical flow, French VF wetland, HYDRUS Wetland Module, CW2D

© 2018 Bernhard Pucher et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
Treatment wetlands, Vertical flow, French VF wetland, HYDRUS Wetland Module, CW2D