<abstract xmlns="http://www.w3.org/1999/xhtml"> Carbon powders produced using a plasma assisted chemical vapor deposition (CVD) methods are an interesting subject of research. One of the most interesting methods of synthesizing these powders is using radio frequency plasma. This method, originally used in deposition of carbon films containing different sp2/sp3 ratios, also makes possible to produce carbon structures in the form of powder. Results of research related to the mechanical modification of these powders have been presented. The powders were modified using a planetary ball mill with varying parameters, such as milling speed, time, ball/powder mass ratio and additional liquids. Changes in morphology and particle sizes were measured using scanning electron microscopy and dynamic light scattering. Phase composition was analyzed using Raman spectroscopy. The influence of individual parameters on the modification outcome was estimated using statistical method. The research proved that the size of obtained powders is mostly influenced by the milling speed and the amount of balls. Powders tend to form conglomerates sized up to hundreds of micrometers. Additionally, it is possible to obtain nanopowders with the size around 100 nm. Furthermore, application of additional liquid, i.e. water in the process reduces the graphitization of the powder, which takes place during dry milling.</abstract>

Carbon powders produced using a plasma assisted chemical vapor deposition (CVD) methods are an interesting subject of research. One of the most interesting methods of synthesizing these powders is using radio frequency plasma. This method, originally used in deposition of carbon films containing different sp2/sp3 ratios, also makes possible to produce carbon structures in the form of powder. Results of research related to the mechanical modification of these powders have been presented. The powders were modified using a planetary ball mill with varying parameters, such as milling speed, time, ball/powder mass ratio and additional liquids. Changes in morphology and particle sizes were measured using scanning electron microscopy and dynamic light scattering. Phase composition was analyzed using Raman spectroscopy. The influence of individual parameters on the modification outcome was estimated using statistical method. The research proved that the size of obtained powders is mostly influenced by the milling speed and the amount of balls. Powders tend to form conglomerates sized up to hundreds of micrometers. Additionally, it is possible to obtain nanopowders with the size around 100 nm. Furthermore, application of additional liquid, i.e. water in the process reduces the graphitization of the powder, which takes place during dry milling.

CVD carbon powders modified by ball milling

Lodz University of Technology, Faculty of Mechanical Engineering, Institute of Materials Science and Technology, Lodz, Poland

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"CVD carbon powders modified by ball milling"}

Carbon powders produced using a plasma assisted chemical vapor deposition (CVD) methods are an interesting subject of research. One of the most interesting...

CVD carbon powders modified by ball milling

Publicado en línea: 30 ago 2016

Páginas: 521 - 528

Recibido: 06 oct 2014

Aceptado: 24 abr 2015

DOI: https://doi.org/10.1515/msp-2015-0072

Palabras clave
carbon powder, CVD, milling, Taguchi method

© 2016

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

CVD carbon powders modified by ball milling

Publicado en línea: 30 ago 2016

Páginas: 521 - 528

Recibido: 06 oct 2014

Aceptado: 24 abr 2015

DOI: https://doi.org/10.1515/msp-2015-0072

Palabras clavecarbon powder, CVD, milling, Taguchi method

© 2016

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Palabras clave
carbon powder, CVD, milling, Taguchi method