<abstract xmlns="http://www.w3.org/1999/xhtml"><p> The paper is focused on the study of thermal stress of surface of mold cavities and parting line of silicone molds after pouring. The silicone mold White SD - THT was thermally stressed by pouring of ZnAl4Cu3 zinc alloy with pouring cycle 20, 30 and 40 seconds. The most thermally stressed part of surface at each pouring cycle is gating system and mold cavities. It could be further concluded that linear increase of the pouring cycle time leads to the exponential increasing of the maximum temperature of mold surface after its cooling. The elongated pouring cycle increases the temperature accumulated on the surface of cavities and the ability of silicone mold to conduct the heat on its surface decreases, because the low thermal conductivity of silicone molds enables the conduction of larger amount of heat into ambient environment.</p></abstract>

The paper is focused on the study of thermal stress of surface of mold cavities and parting line of silicone molds after pouring. The silicone mold White SD - THT was thermally stressed by pouring of ZnAl4Cu3 zinc alloy with pouring cycle 20, 30 and 40 seconds. The most thermally stressed part of surface at each pouring cycle is gating system and mold cavities. It could be further concluded that linear increase of the pouring cycle time leads to the exponential increasing of the maximum temperature of mold surface after its cooling. The elongated pouring cycle increases the temperature accumulated on the surface of cavities and the ability of silicone mold to conduct the heat on its surface decreases, because the low thermal conductivity of silicone molds enables the conduction of larger amount of heat into ambient environment.

Thermal Stress of Surface of Mold Cavities and Parting Line of Silicone Molds

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology Bratislava, Paulínska 16, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Thermal Stress of Surface of Mold Cavities and Parting Line of Silicone Molds"}

The paper is focused on the study of thermal stress of surface of mold cavities and parting line of silicone molds after pouring. The silicone mold White SD -...

Thermal Stress of Surface of Mold Cavities and Parting Line of Silicone Molds

Online veröffentlicht: 25. Nov. 2014

Seitenbereich: 7 - 14

DOI: https://doi.org/10.2478/rput-2014-0021

Schlüsselwörter
silicone mold, thermal stress, spin casting

© by Matej Beznák

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Thermal Stress of Surface of Mold Cavities and Parting Line of Silicone Molds

Online veröffentlicht: 25. Nov. 2014

Seitenbereich: 7 - 14

DOI: https://doi.org/10.2478/rput-2014-0021

Schlüsselwörtersilicone mold, thermal stress, spin casting

© by Matej Beznák

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Schlüsselwörter
silicone mold, thermal stress, spin casting