Aircraft Turbine Engine Automatic Control Based on Adaptive Dynamic Models

One of the most perspective development directions of the aircraft engine is the application of adaptive digital automatic control systems (ACS). The significant element of the adaptation is the correction of mathematical models of both engine and its executive, measuring devices. These models help to solve tasks of control and are a combination of static models and dynamic models, as static models describe relations between parameters at steady-state modes, and dynamic ones characterize deviations of the parameters from static values.

The work considers problems of the models’ correction using parametric identification methods. It is shown that the main problem of the precise engine simulation is the correction of the static model. A robust procedure that is based on a wide application of a priori information about performances of the engine and its measuring system is proposed for this purpose. One of many variants of this procedure provides an application of the non-linear thermodynamic model of the working process and estimation of individual corrections to the engine components’ characteristics with further substitution of the thermodynamic model by approximating on-board static model. Physically grounded estimates are obtained based on a priori information setting about the estimated parameters and engine performances, using fuzzy sets.

Executive devices (actuators) and the most inertial temperature sensors require correction to their dynamic models. Researches showed, in case that the data for identification are collected during regular operation of ACS, the estimates of dynamic model parameters can be strongly correlated that reasons inadmissible errors.

The reason is inside the substantial limitations on transients’ intensity that contain regular algorithms of acceleration/deceleration control. Therefore, test actions on the engine are required. Their character and minimum composition are determined using the derived relations between errors in model coefficients, measurement process, and control action parameters.