<abstract xmlns="http://www.w3.org/1999/xhtml">The current paper aims to study, using numerical simulation, the influence of the wall angle on the single point incremental forming process. For the analysis there has been used the LS-Dyna software and three explicit dynamic analyses were run for three parts with wall angles of 450, 550 and 650. The factors taken into account are the main strains, the thickness reduction and the forces on three directions. The material data introduced into the simulation were determined based on an uniaxial traction test on an Instron 5587 testing machine and the Aramis system was used as optical extensometer.</abstract>

The current paper aims to study, using numerical simulation, the influence of the wall angle on the single point incremental forming process. For the analysis there has been used the LS-Dyna software and three explicit dynamic analyses were run for three parts with wall angles of 450, 550 and 650. The factors taken into account are the main strains, the thickness reduction and the forces on three directions. The material data introduced into the simulation were determined based on an uniaxial traction test on an Instron 5587 testing machine and the Aramis system was used as optical extensometer.

Numerical Study about the Influence of Wall Angle about Main Strains, Thickness Reduction and Forces on Single Point Incremental Forming Process

Professor / Ph.D., Faculty of Engineering / Department of Industrial Machinery and Equipment, “Lucian Blaga” University of Sibiu, Sibiu,

Acta Universitatis Cibiniensis. Technical Series

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The current paper aims to study, using numerical simulation, the influence of the wall angle on the single point incremental forming process. For the analysis...

Numerical Study about the Influence of Wall Angle about Main Strains, Thickness Reduction and Forces on Single Point Incremental Forming Process

Published Online: Dec 30, 2016

Page range: 1 - 6

DOI: https://doi.org/10.1515/aucts-2016-0001

Keywords
Wall angle, Incremental Forming, Numerical simulation, Explicit analysis, Main strains, Thickness reduction, Forces

© 2016 Oleksik Valentin, published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Numerical Study about the Influence of Wall Angle about Main Strains, Thickness Reduction and Forces on Single Point Incremental Forming Process

Published Online: Dec 30, 2016

Page range: 1 - 6

DOI: https://doi.org/10.1515/aucts-2016-0001

KeywordsWall angle, Incremental Forming, Numerical simulation, Explicit analysis, Main strains, Thickness reduction, Forces

© 2016 Oleksik Valentin, published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
Wall angle, Incremental Forming, Numerical simulation, Explicit analysis, Main strains, Thickness reduction, Forces