<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Machining of aluminum and its alloys requires the use of cutting tools with special geometry and material. Since there exists a number of cutting tools for aluminum machining, each with unique characteristics, selection of the most appropriate cutting tool for a given application is very complex task which can be viewed as a multi-criteria decision making (MCDM) problem. This paper is focused on multi-criteria analysis of VCGT cutting inserts for aluminum alloys turning by applying recently developed MCDM method, i.e. weighted aggregated sum product assessment (WASPAS) method. The MCDM model was defined using the available catalogue data from cutting tool manufacturers.</p></abstract>

Machining of aluminum and its alloys requires the use of cutting tools with special geometry and material. Since there exists a number of cutting tools for aluminum machining, each with unique characteristics, selection of the most appropriate cutting tool for a given application is very complex task which can be viewed as a multi-criteria decision making (MCDM) problem. This paper is focused on multi-criteria analysis of VCGT cutting inserts for aluminum alloys turning by applying recently developed MCDM method, i.e. weighted aggregated sum product assessment (WASPAS) method. The MCDM model was defined using the available catalogue data from cutting tool manufacturers.

Selection Of Cutting Inserts For Aluminum Alloys Machining By Using MCDM Method

Faculty of Mechanical Engineering in Niš / Department for Production, IT and Management, University of Niš, Niš, Serbia

Faculty of Engineering / Department for production engineering, University of Kragujevac, Kragujevac, Serbia

Acta Universitatis Cibiniensis. Technical Series

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Selection Of Cutting Inserts For Aluminum Alloys Machining By Using MCDM Method"}

Machining of aluminum and its alloys requires the use of cutting tools with special geometry and material. Since there exists a number of cutting tools for...

Selection Of Cutting Inserts For Aluminum Alloys Machining By Using MCDM Method

Published Online: Sep 23, 2015

Page range: 98 - 101

DOI: https://doi.org/10.1515/aucts-2015-0035

Keywords
aluminum alloys, machining, turning, multi-criteria decision making, WASPAS method

© Madić Miloš et al.

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Selection Of Cutting Inserts For Aluminum Alloys Machining By Using MCDM Method

Published Online: Sep 23, 2015

Page range: 98 - 101

DOI: https://doi.org/10.1515/aucts-2015-0035

Keywordsaluminum alloys, machining, turning, multi-criteria decision making, WASPAS method

© Madić Miloš et al.

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
aluminum alloys, machining, turning, multi-criteria decision making, WASPAS method