<abstract xmlns="http://www.w3.org/1999/xhtml"><p> A drive system of a section of a metallurgical rolling table consisting of six dc motors, 2220 amperes of total current, fed from a single ABB reversible thyristor converter has been described in this paper. Autonomous excitation circuits of the motors are fed from independent thyristor converters working in the so called MULTIFEX system linked with a supervisory high power converter. There are presented schemes of the DSL communication realized by FEX excitation cards of the motors using the SDSC card of the DCS-800-S02 converter and logic control system based on a PLC controller. The parameterization of the DCS-800 converter and the DCF 803 excitation systems was conducted using the DriveWindow software tool. Significant waveforms of voltages, currents and the estimated motor velocity are described and presented for the idle run as well as during transporting sheets discharged from a pusher furnace.</p></abstract>

A drive system of a section of a metallurgical rolling table consisting of six dc motors, 2220 amperes of total current, fed from a single ABB reversible thyristor converter has been described in this paper. Autonomous excitation circuits of the motors are fed from independent thyristor converters working in the so called MULTIFEX system linked with a supervisory high power converter. There are presented schemes of the DSL communication realized by FEX excitation cards of the motors using the SDSC card of the DCS-800-S02 converter and logic control system based on a PLC controller. The parameterization of the DCS-800 converter and the DCF 803 excitation systems was conducted using the DriveWindow software tool. Significant waveforms of voltages, currents and the estimated motor velocity are described and presented for the idle run as well as during transporting sheets discharged from a pusher furnace.

Integrated Multimotor Electrical DC Drive for Metallurgical Rolling Table

Faculty of Electrical Engineering, Czestochowa University of Technology, Al. Armii Krajowej 17, 42-200 Częstochowa, Poland

Faculty of Management, Czestochowa University of Technology, Al. Armii Krajowej 17, 42-200 Częstochowa, Poland

Acta Mechanica et Automatica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Integrated Multimotor Electrical DC Drive for Metallurgical Rolling Table"}

A drive system of a section of a metallurgical rolling table consisting of six dc motors, 2220 amperes of total current, fed from a single ABB reversible...

Integrated Multimotor Electrical DC Drive for Metallurgical Rolling Table

Published Online: Aug 14, 2015

Page range: 93 - 98

Received: Sep 07, 2014

Accepted: May 28, 2015

DOI: https://doi.org/10.1515/ama-2015-0016

Keywords
DC Drive System, Rolling Table, FEX Excitation System, Drivewindow Software

© Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Integrated Multimotor Electrical DC Drive for Metallurgical Rolling Table

Published Online: Aug 14, 2015

Page range: 93 - 98

Received: Sep 07, 2014

Accepted: May 28, 2015

DOI: https://doi.org/10.1515/ama-2015-0016

KeywordsDC Drive System, Rolling Table, FEX Excitation System, Drivewindow Software

© Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
DC Drive System, Rolling Table, FEX Excitation System, Drivewindow Software