Open access


Yielding support, commonly applied to secure dog headings, is made of carrying elements in the form of steel frames and friction props. Yielding capacity of this support is realized in frictional joints, which due to their geometry can be divided to straight and arch joints. Occurring in steel frames arch frictional joints are characterized with more complex loading state than straight joints used in friction props. In the article, there is presented an analysis of the state of stress and deformation of the arch frictional joint, which was carried out on the model of these joints using finite element method. The scope of the analysis included two methods of loading of arch frictional joint, namely its axial compression and bending. In both cases, joints were loaded dynamically with the impact of freely falling mass. Arch joints with and without passive pressure were submitted to an axial compression. Physical model of the frictional joint was developed on the basis of a system applied during the stand tests. To solve mathematical model an explicit integration method was used. As a result of analyses carried out, temporal courses of force transmitted through the frictional joint, and displacements of section sliding down were determined. On the basis of the temporal courses, dependences between maximum value of force transmitted through the frictional joint and the height from which the impact mass falls down were determined. Distributions of reduced stresses in elements of frictional joint were also determined and the state of deformation was described. In order to emphasize the difference between straight and arch frictional joints, also an analysis of internal forces in arch frictional joint depending on its geometrical parameters without and with passive pressure was presented.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • [1] BRODNY J. Analiza obciążenia łukowego złącza ciernego Mechanizacja i Automatyzacja Górnictwa Czasopismo Naukowo-Techniczne 12(490) 2011 13-19.

  • [2] BRODNY J. Tests of friction joints in mining yielding supports under dynamic load Archives of Mining Sciences Vol. 56 No. 2 2011.

  • [3] CRISFIELD M.A. Non-Linear Finite Element Analysis of Solids and Structures John Wiley & Sons 1998.

  • [4] PYTLIK A. Wpływ zginania na prace ciernych złączy łukowych odrzwi ŁP przy obciążeniach statycznych i dynamicznych praca doktorska GIG Katowice 2001.

  • [5] SKRZYŃSKI K. Analiza wpływu rozpór i okładzin na stateczność przestrzenną stalowej obudowy odrzwiowej praca doktorska GIG Katowice 1996.

  • [6] SZMELTER J. Metody komputerowe w mechanice PWN Warszawa 1980.

  • [7] TAYLOR J.R. Mechanika klasyczna T. 1 Wydawnictwo Naukowe PWN Warszawa 2006.

  • [8] ZIENKIEWICZ O.C. TAYLOR R.C. The Finite Element Method Butterworth-Heinemann London 2000.

Impact Factor

CiteScore 2018: 1.03

SCImago Journal Rank (SJR) 2018: 0.213
Source Normalized Impact per Paper (SNIP) 2018: 1.106

Cited By
Gesamte Zeit Letztes Jahr Letzte 30 Tage
Abstract Views 0 0 0
Full Text Views 90 35 2
PDF Downloads 65 32 1