In memoriam – zaslužni profesor dr. Uroš Bajželj

<abstract xmlns="http://www.w3.org/1999/xhtml">The present article is dedicated to the study of the vibration properties of metal-based composite materials and the application of the non-destructive testing method. The main modal parameters of the metal-based composites were investigated. For experimental determination of natural frequencies and modes of oscillations, the method of scanning laser Doppler vibrometry was used. For the numerical modal analysis, the finite element method was used. The material model was a layered composite with isotropic linearly elastic layers and metal layers. The task of identifying the material model was considered as the problem of minimising the discrepancy between the calculated natural frequencies and the experimental ones. The developed method can be recommended for the determination of parameters of material models for calculating the modal characteristics of polymer–metal sandwich sheets and metallic mono-materials composite products. Methodology for identifying models of elastic behaviour of polymer–metal composite materials, based on the results of the experimental modal analysis, is presented. Wavelet-based damage detection is also presented as an appropriate approach for the identification of integral conditions of the metal–polymer–metal composite materials. Results of wavelet transform convolutions are presented.</abstract>

Faculty of Technology, School of Engineering

Investigation of Metal-based Composites Vibration Properties Using Modal Analysis in Combination with Wavelet Transforms Under Imitation of Operational Loads

<abstract xmlns="http://www.w3.org/1999/xhtml">Microstructure of austenitic stainless steel is primarily monophasic, i.e. austenitic. However, precipitation of the δ-ferrite in the austenite matrix is possible depending on the chemical composition of steel. δ-Ferrite is stable on room temperature but it transforms into σ-phase, carbides and austenite during heat treatment. In this work, the results of analysis of influence of temperature and time on decomposition of δ-ferrite are presented. Magnetic induction method, microstructure and hardness analyses were used for testing the degree of decomposition of the δ-ferrite. Analysis of results showed that increase in temperature and time increases the degree of decomposition of δ-ferrite.</abstract>

Effect of Temperature and Time on Decomposition of δ-ferrite in Austenitic Stainless Steel

<abstract xmlns="http://www.w3.org/1999/xhtml">During 1984–1997, the ferronickel plant in Drenas used iron-nickel ore from the mines of the Republic of Kosovo: Glavica and Çikatove (Dushkaje and Suke) mines. However, during the years 2007–2017, when the plant started operating from the cessation of production, which was from 1998 to 2007, some types of iron-nickel ores from different countries began to be used, starting from iron-nickel ores from Kosovo, iron-nickel ores from Albania, ores from Indonesia, ores from the Philippines, ores from Guatemala, ores from Turkey and ores from Macedonia. The ore composition, however, is mainly oxide-laterite ore. Iron-nickel ores in the plant are characterised by high moisture content, a very important factor influencing the process of scraping the charge in rotary kilns and presenting in general. Among the iron-nickel ore used in the ferronickel plant, the ores from Albania are characterised due to their low moisture content when compared with the other ores as well as the high content of iron oxides, which affect the temperature rise inside the furnaces, as the iron ores play an important role in the pre-casting process in rotary kilns.</abstract>

Faculty of Geoscience, Department of Materials and Metallurgy

University of Mitrovica “Isa Boletini”

New Foundry of the New Ferronickel in Drenas

Key Metallurgical Parameters of Fe-Ni Production During 1984–1997 and 2007–2017 at the Ferronickel Smelter in Drenas

<abstract xmlns="http://www.w3.org/1999/xhtml">Primary, secondary and accessory minerals in tonalitic rocks from Iwo region of the Precambrian Basement Complex of Southwestern Nigeria were identified and analysed with the aim of determining the various processes involved during the crystallisation of magma. Thin sections of tonalite were prepared and studied with the aid of a petrographic microscope. The mineral assemblages observed are biotite, plagioclase, alkali-feldspar, amphiboles, pyroxene, quartz, muscovite and chlorite. Allanite, titanite, apatite and zircon occur as accessory minerals. Muscovite and chlorite are found to be secondary minerals. The mineral allanite has a characteristic form of zoning and shows evidence of metamictisation, and is surrounded by dark-coloured biotite having radioactive haloes. Titanite is anhedral to subhedral crystals and forms reaction rim round opaque minerals. Plagioclase shows evidence of compositional zoning as well as plastic deformation of the twin lamellae. The allanite observed is primary in nature and has undergone radioactive disintegration; chlorite and muscovite are formed by secondary processes of chloritization and sericitisation, respectively. The tonalite is formed as a result of rapid cooling of magma close to the Earth's surface.</abstract>

Department of Geosciences, Faculty of Science

Department of Geological Science, College of Science, Engineering and Technology

Petrography of Allanite-bearing Tonalite from Iwo Region, Osun State, Nigeria

AHEAD OF PRINT

Volume 69 (2022): Issue 2 (December 2022)

Volume 69 (2022): Issue 1 (June 2022)

Volume 68 (2021): Issue 2 (December 2021)

Volume 68 (2021): Issue 1 (March 2021)

Volume 67 (2020): Issue 4 (December 2020)

Volume 67 (2020): Issue 3 (September 2020)

Volume 67 (2020): Issue 2 (June 2020)

Volume 67 (2020): Issue 1 (March 2020)

Volume 66 (2019): Issue 4 (December 2019)

Volume 66 (2019): Issue 3 (December 2019)

Volume 66 (2019): Issue 2 (June 2019)

Volume 66 (2019): Issue 1 (March 2019)

Volume 65 (2018): Issue 4 (December 2018)

Volume 65 (2018): Issue 3 (September 2018)

Volume 65 (2018): Issue 2 (September 2018)

Volume 65 (2018): Issue 1 (March 2018)

Volume 64 (2017): Issue 4 (December 2017)

Volume 64 (2017): Issue 3 (September 2017)

Volume 64 (2017): Issue 2 (July 2017)

Volume 64 (2017): Issue 1 (March 2017)

Volume 63 (2016): Issue 4 (December 2016)

Volume 63 (2016): Issue 3 (September 2016)

Volume 63 (2016): Issue 2 (July 2016)

Volume 63 (2016): Issue 1 (June 2016)

Materials and Geoenvironment

 Description:  Old title: Rudarsko-metalurški zbornik (Mining and Metallurgy Quaterly).  Is issued quarterly by the Faculty of Natural Sciences and Engineering, Ljubljana, Velenje Coal Mine, Velenje, Institute for Mining, Geotechnology and Environment (IRGO), Ljubljana and Slovenian Chamber of Engineers, Ljubljana.  Financially supported also by Ministry of Higher Education, Science and Technology Republic of Slovenia.  Issues up to the volume 62 you can find on our old web page at address: www.rmz-mg.com/contents.htm  The journal does not have article processing charges (APCs) nor article submission charges.  Archiving  Sciendo archives the contents of this journal in Portico - digital long-term preservation service of scholarly books, journals and collections.  Plagiarism Policy  The editorial board is participating in a growing community of Similarity Check System's users in order to ensure that the content published is original and trustworthy. Similarity Check is a medium that allows for comprehensive manuscripts screening, aimed to eliminate plagiarism and provide a high standard and quality peer-review process. 