<abstract xmlns="http://www.w3.org/1999/xhtml"> An optimally designed geodetic network is characterised by an appropriate level of precision and the lowest possible setup cost. Reliability, translating into the ability to detect blunders in the observations and higher certainty of the obtained point positions, is an important network characteristic. The principal way to provide appropriate network reliability is to acquire a suitably large number of redundant observations. This approach, however, faces limitations resulting from the extra cost. This paper analyses the possibility of providing appropriate reliability parameters for networks with moderate redundancy. A common problem in such cases are dependencies between observations preventing the acquisition of the required reliability index for each of the individual observation. The authors propose a methodology to analyse dependencies between observations aiming to determine the possibility of acquiring the optimal reliability indices for each individual observation or groups of observations. The suggested network structure analysis procedures were illustrated with numerical examples.</abstract>

Impact analysis of observation coupling on reliability indices in a geodetic network

<abstract xmlns="http://www.w3.org/1999/xhtml"> The article presents an example of supplementing geotechnical monitoring with geodetic observations. The experimental flood embankment built within the ISMOP project (Information Technology System of Levee Monitoring) was subjected to continuous monitoring based on built-in measuring sensors. The results of geodetic monitoring used for observation of earth-filled flood embankment subjected to external loads are presented in the paper. The tests were carried out on an experimental food embankment forming a closed artificial water reservoir. The observations were carried out for two purposes. The first was long-term monitoring, which was aimed to determine the behaviour of the newly built embankment. The second purpose was to check the reaction of the levee to the simulated flood wave, caused by filling and draining the reservoir. In order to monitor the displacements of the earth-filled embankment, it was necessary to develop the proper methodology. For the needs of research works, an appropriate network of 5 reference points and 48 survey markers has been designed and established. The periodic measurements were carried out using precise robotic total station. The stability of the reference frame was each time checked and displacements of survey markers were determined based on it. The final results allow to reveal the reaction of levee to external loads. The displacement values were referred to the course of the filling and draining experiment to indicate the relationship between them. In the field of long-term monitoring the results clearly imply the dominance of displacements outside the reservoir for points located on the embankment, in contrast to points on the crest and foreground, which do not show significant movements. On the other hand, in the field of testing the embankment reaction to the flood wave, obtaining reliable results was possible thanks to high-accuracy geodetic measurements. Small displacement values, often at the level of their determination errors, were averaged for groups of points with the same height of foundation. A sizable number of points allows to perceive some tendencies and the relation between embankment soaking, hence its movement directions can be noticed. During periods when the levee was still saturated with water, slight movements outside the reservoir were revealed. On the other hand, the following period of drying caused movement in the opposite direction.</abstract>

Geodetic monitoring of earth-filled flood embankment subjected to variable loads

<abstract xmlns="http://www.w3.org/1999/xhtml"> Nowadays, the growing popularity of terrestrial laser scanners (TLS) allows to obtain a point cloud of many industrial objects along with classic surveying. However, the quality and model’s accuracy in comparison to a real shape seem to be a question, that must be further researched. It is crucial especially for Finite Element Method (FEM) analysis, which, being a part of technical design, estimate the values of construction’s dislocation and deformation. The article describes objects such as headgear with steel support and 4-post headframe with steel sheers. Both supports and sheers were modelled basing on point clouds. All the models were compared to the point cloud. The differences in models’ shape were calculated and the maximal values were determined. The results’ usefulness in FEM analysis was described.</abstract>

Headframe modelling accuracy for finite element method analysis purposes

<abstract xmlns="http://www.w3.org/1999/xhtml"> Records of municipal planning documents directly affect the land use. In this way, the market price of the land is also shaped. Awareness of the economic and social consequences of adapting specific solutions is the primary argument that should condition the local policy in terms of spatial planning. The research results indicate that the network trained with attributes which do not describe a property value by its price was able to estimate it with acceptable and satisfactory results. The possibility to use artificial multilayer networks in spatial policy decision-making seems well founded. The research results show the relevance of the assumption that using them for modeling can be helpful in selecting the most advantageous variant of planning arrangements in a local law document which determines the land use and development, therefore impacts its value.</abstract>

The use of urban indicators in forecasting a real estate value with the use of deep neural network

<abstract xmlns="http://www.w3.org/1999/xhtml"> Twenty four hour GNSS (Global Navigation Satellite System) data acquired monthly for 5 years from 8 CORS (Continuously Operating Reference Station) stations in Central Valley, California are processed and vertical velocities of the points are determined. To process GNSS data, online GNSS data processing service APPS (Automatic Precise Positioning Service) is used. GNSS data downloaded from NGS (National Geodetic Survey) CORS are analyzed and subsidence at these points is portrayed with graphics. It is revealed that elevation changes range from 5 mm uplift in the north to 163 mm subsidence in the southern part of the valley.</abstract>

Subsidence determination in the Central Valley, California

AHEAD OF PRINT

Volume 117 (2024): Issue 1 (June 2024)

Volume 116 (2023): Issue 1 (December 2023)

Volume 115 (2023): Issue 1 (June 2023)

Volume 114 (2022): Issue 1 (December 2022)

Volume 113 (2022): Issue 1 (June 2022)

Volume 112 (2021): Issue 1 (December 2021)

Volume 111 (2021): Issue 1 (June 2021)

Volume 110 (2020): Issue 1 (December 2020)

Volume 109 (2020): Issue 1 (June 2020)

Volume 108 (2019): Issue 1 (December 2019)

Volume 107 (2019): Issue 1 (June 2019)

Volume 106 (2018): Issue 1 (December 2018)

Volume 105 (2018): Issue 1 (June 2018)

Volume 104 (2017): Issue 1 (December 2017)

Volume 103 (2017): Issue 1 (June 2017)

Volume 102 (2016): Issue 1 (December 2016)

Volume 101 (2016): Issue 1 (June 2016)

Volume 100 (2016): Issue 1 (May 2016)

Volume 99 (2015): Issue 1 (December 2015)

Volume 98 (2015): Issue 1 (July 2015)

Volume 97 (2014): Issue 1 (December 2014)

Volume 96 (2014): Issue 1 (June 2014)

Volume 95 (2013): Issue 1 (December 2013)

Volume 94 (2013): Issue 1 (October 2013)

Reports on Geodesy and Geoinformatics

 Reports on Geodesy and Geoinformatics (formerly Reports on Geodesy) is recognized as a semi-annual scientific journal that has appeared since 1991. The volumes of this journal had been prepared and edited by the staff of the Institute of Geodesy and Geodetic Astronomy until 2008 and then during the reorganization of the Faculty of Geodesy and Cartography between years 2008-2011 the volumes were edited and printed by the scientists of the Department of Geodesy and Geodetic Astronomy of Warsaw University of Technology (WUT). Since 2012 the journal has been edited by the scientific staff of the Faculty of Geodesy and Cartography of WUT.  Each paper submitted for publishing in Reports on Geodesy and Geoinformatics is peer-reviewed. The list of our revisers contains more than 200 scientists both from Poland as well as from other countries. Our revisers are recognized specialists from different branches of geodesy and cartography. In some issues of Reports on Geodesy and Geoinformatics there are presented contents of papers announced at international conferences and such volumes may be recognized as the proceedings from these scientific meetings.  All papers published in Reports on Geodesy and Geoinformatics are available in an open access formula. All of them have been also distributed among over 110 libraries in Poland as well as foreign institutions and are considered to be very well acknowledged by the international geodetic community.  Peer-review. The journal uses single-blind peer review (the authors do not know the reviewers) to avoid bias. See more information &lt;Peer Review&gt;.  Journal policies. The journal provides its’ policies, which include detailed information about submission, editorial and publishing processes and guidelines for authors and reviewers. All parties are being introduced to their rights and responsibilities to ensure smooth and ethical publishing process. See more information &lt;Journal Policies&gt;  Fees and Charges. The journal operates as open access journal, the process is completely free of charges to both authors and readers. All publication fees are covered by Warsaw University of Technology.　  Publication schedule. The journal is semi-annual (2 Issues per year in June and December). All articles are published online under CC BY-NC-ND licence 4.0 within four weeks after acceptance as a continuous publication (Online first) to avoid any delays.　  Copyright. Individual articles are published Open Access under the Creative Commons Licence: CC BY-NC-ND 4.0, which permits non-commercial use, distribute, display and perform only original copies of the work in any medium, provided the original author and source are credited. Authors retain copyright in their articles, but grant RGG the right of the first publication. The journal is copyright RGG © Warsaw University of Technology (WUT), all rights reserved.   Aims and ScopeReports on Geodesy and Geoinformatics in keeping with tradition, is intent on presenting the whole of technological and scientific progress taking place in modern geodesy and cartography, where research and implementation of geoinformatic character play an exceptionally important role in accelerating the development of our discipline. It is for this reason that we have decided to expand the journal’s formula so as to encourage a broader group of scientists and specialists in the realms of geodesy, computer science, cartography, photogrammetry, remote sensing, geography, geology, and related sciences who are developing new methods and technologies of geovisualization and are involved in the modeling of space applying GIS technology to collaborate with us. At the same time, the journal’s profile shall maintain the importance of other theoretical, industrial, and development research in the areas of theoretical geodesy, geodetic astronomy, navigation, and studies on displacements and the classic problems facing geodesic surveying.  Journal PoliciesThe journal provides its’ policies, which include detailed information about submission, editorial and publishing processes and guidelines for authors and reviewers. All parties are being introduced with their rights and responsibilities to ensure smooth and ethical publishing process. Visit following subsections for more details on each policy:    Publication Ethics and Publication Malpractice Statement  Open Access  Privacy Statement   Reports on Geodesy and Geoinformatics (formerly Reports on Geodesy) in keeping with tradition, is intent on presenting the whole of technological and scientific progress taking place in modern geodesy and cartography, where research and implementation of geoinformatic character play an exceptionally important role in accelerating the development of our discipline. It is for this reason that we have decided to expand the journal's formula so as to encourage a broader group of scientists and specialists in the realms of geodesy, computer science, cartography, photogrammetry, remote sensing, geography, geology, and related sciences who are developing new methods and technologies of geovisualization and are involved in the modeling of space applying GIS technology to collaborate with us. At the same time, the journal's profile shall maintain the importance of other theoretical, industrial, and development research in the areas of theoretical geodesy, geodetic astronomy, navigation, and studies on displacements and the classic problems facing geodesic surveying.Internet access to complete articles in an "open access" formula will significantly facilitate use by those who are interested as well as expand the circle of readers.  Archiving  Sciendo archives the contents of this journal in Portico - digital long-term preservation service of scholarly books, journals and collections.  Plagiarism Policy  The editorial board is participating in a growing community of Similarity Check System's users in order to ensure that the content published is original and trustworthy. Similarity Check is a medium that allows for comprehensive manuscripts screening, aimed to eliminate plagiarism and provide a high standard and quality peer-review process. 