Effect of tribological conditions for properties thermal spraying

Mariana Landová 1  and Janette Brezinová 1
  • 1 Technical University of Košice, Faculty of Mechanical Engineering, Department of Technology and Materials, 04001, Košice

Abstract

The present contribution deals with the influence of tribological conditions on coating quality. Two types of coatings were selected for analysis WC-WB-CO and WC-FeCrAl, to advise that a new type of coating - carbide green. These coatings were applied to the base material AISI 316L of technology HVOF – High velocity oxygen fuel. The aim of the experimental study was to determine the quality coatings and its resistance to abrasive wear, depending on the number of thermal cycles. It was evaluated hardness, thickness, the resistance to abrasive wear in free abrasives and firmly bonded abrasives. Results of experiments showed a higher resistance of the coating WC-Co-WB.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • 1. Alvarado-Orozcoj. E. A. et al. 2016. Electrochemical Corrosion of HVOF-Sprayed NiCoCrAlY Coatings in CO2-Saturated Brine. Journal of Thermal Spray Technology 25/7, 1330–1343.

  • 2. Bolelli G. A. et al. 2014. Comparative Study of the Dry Sliding Wear Behaviour of HVOF Sprayed WC-(W, Cr) 2C Ni and WC-CoCr Hardmetal Coatings, “Wear” 309, 96-111.

  • 3. Brezinová J. A. et al. 2015. Quality Evaluation of HVOF Coatings on the Basis of WC-Co in Tribocorrosive Conditions. „Mater. Sci. Forum“ 811, 63-66.

  • 4. Guilemany J. M A. et al. 2001. Role of three-body abrasion wear in the sliding wear behaviour of WC-Co coatings obtained by thermal spraying. „Surf. Coat. Technol“ 140/2, 141-146.

  • 5. Sahraoui T. A. et al. 2010. HVOF sprayed WC–Co coatings: Micro-structure, mechanical properties and friction moment prediction. “Mater. Des” 31/3, 1431-1437.

  • 6. Viňáš J. A. et al. 2013. Tribological properties of selected ceramic coatings. „ J. Adh. Sci. Technol“ 27/2, 196-207.

OPEN ACCESS

Journal + Issues

Search