Tooling Development for Thermoplastic Composites Thermoforming Process Based on FEM Analysis – a Rib Case Study

Open access

Abstract

Remarkable characteristics of high temperature thermoplastic (HTP) matrix used in composite materials reinforced with continuous fibres causes growing application in composite industry. Because of high processing temperature of some semi, crystalline matrix there is limited number of technologies that can be used for part manufacturing. Press forming is an example of technology that allows manufacturing high quality complex parts made of HTP reinforced fibres composite. In order to manufacture part with acceptable quality and mechanical properties, uniform pressure distribution during the process is required.

In this article, tooling design process focused on uniform pressure distribution for manufacturing of supporting rib was presented. In order to satisfy this requirement, the rubber stamp was proposed as a tool for manufacturing. Typical press forming process defects were identified and the requirements for rubber stamp were described. It was assumed that the forming process has to begin at one point on mould surface and sequentially continue in all directions. For stamp material, the two components additive silicone was selected. The hardness of the silicone was equal 40 Shore A. The rubber mechanical properties was determined through the additional tests and used for stamp designing. The tooling was designed using FEM software ABAQUS 6.12.

The sequence of stamp shape designing and optimization in order to meet the stamp requirements was presented. At the end the FEM rubber stamp designing recommendation were presented.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • [1] Waśniewski B. Duroplasty oraz termoplasty wysokotemperaturowe w prepregach jako osłony kompozytów węglowych do wytwarzania struktur lotniczych Trans Inst Aviat 243:28-39 doi:10.5604/05096669.1205232 2016.

  • [2] Campbell F. C. Manfacturing processes for advanced composites Elsevier New York 2004.

  • [3] TenCate Advanced Composites TenCate Cetex TC1100 Product Data Sheet.

  • [4] Akkerman R Haanappel SP. 6 Thermoplastic composites manufacturing by thermoforming A2 – Boisse Philippe. Adv. Compos. Manuf. Process Des. Woodhead Publishing pp. 111-129 doi:10.1016/B978-1-78242-307-2.00006-3 2015.

  • [5] Robroek L. The Development of Rubber Forming as a Rapid Thermoforming Technique for Continuous Fibre Reinforced Thermoplastic Composites 1994.

  • [6] Abaqus Analysis User’s Manual – Dokumentacja programu Abaqus 6.12.

Search
Journal information
Metrics
All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 5 5 5
PDF Downloads 11 11 11