An Investigation Concerning the Effect of Canal width Contraction that May be Needed in the Location of Constructing Some Irrigation Works

Open access

Abstract

The compatibility between the needed structural designed dimensions of the irrigation works and the dimensions of the water stream or the canal in which the irrigation work will be located has a great importance from more than one point of view. As it is well known, the main aim of the designer of such works is to reach the optimum design for maximum performance efficiency with economical cost, and minimize negative technical impacts that may be harmful to the safety of the whole work. Since the complete suitability between the obtained designed dimensions of the different construction elements of the work, and the original properties and dimensions of the canal in which the work will be constructed, is rarely occurring. The designer always has to make some changes in the original engineering properties and dimensions of canals, such as bed width, bed level, and/or inside side slope, to reach the needed suitable compatibility between the structural design and the natural original canal cross section. For the economical purposes, the design always needs less width of the work, than the width of the bed of the original stream cross section, so a contraction may be needed where the work will be constructed; the literature indicated that, such a contraction must not be less than 0.6 of the original bed width. That contraction, of course, has a direct impact on the different hydraulic parameters, such as water depth, velocity, and flow regime in the location of the work. Changes of such hydraulic parameters may exceed their safe permissible values, and so the whole structure may face some dangerous situations, which must be overcome. In this paper, we present a technical survey of the previous research concerning canal width contraction, with the needed technical comments, and comparisons as a logical approach for a master-thesis under the same title.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • Abou-Seida Mostafa T. M. S. lsaeed G.H. and Elzahry E. F. M. (2009) “Experimental investigation of abutment scour in sandy soil” J.Appl. Sci. Res. 5 (1) 57–65 Faculty of Engineering (Shoubra) Benha University Egypt.

  • Attia M. I. and Ibrahim A. A. (2000) “A study of the effect of channel contraction on turbulence characteristics using Laser Doppler Velocimetry” Scientific Bulletin Faculty of Engineering Ain Shams University Cairo Egypt Vol.35 No.2. pp. 169-182.

  • Attia M. I. and Alhomidan A. (2013) “Effect of free surface and froude number on the protection length and turbulence in the compound transitions through bridges” International Journal of Research in Engineering and Technology.

  • Devadason (2007) “Contraction in compound channels with cohesive soil beds” Master of Science Government College of Engineering Tirunelveli India.

  • Dey S. and Raikar V. (2005) “Scour in long contractions” Journal of Hydraulic Engineering Vol. 131 No. 12 pp. 1036–1049.

  • Egyptian code of water resources and irrigation works (2003) “Civil structures of irrigation and drainage” Vol. 3 Chapter 7 page 5-6.

  • Henderson F. M. (1966) “Open channel flow” MacMilliam Publishing Co. Inc. New York USA pp. 522.

  • Eid M.A.A. and Mohammed M.I.I. (2016) “Effect of erodible bed on backwater rise due to bridge piers only in case of sub critical flow”.

  • Nashta C. F. and Garde R. J. (1988) “Subcritical flow in rigid-bed open channel expansions” Hydr. Res. 26(1) 49-65.

  • Nashta C. F. and Garde R. J. and Swa Mee P. K. (1987) “Subcritical flow in open channel expansions with a movable bed” Journal of Hydraulic Research.

  • Negm A. M. (2001) “Flow Characteristics at Asymmetric Sudden Contraction” Proc. of IWTC-VI Alex. Egypt March 23-25 2001 pp.5-19.

  • Negm A. M. Abdel-Aal G. M. Saleh O. K and Sauida M. F. (2002) “Effect of supercritical flow on scour characteristics downstream of sudden expanding stilling basins” Egyptian Journal of Engineering Science and Technology EJEST Vol. 6 No. 1 PP. 1-13.

  • Negm A. M. Elfiky M. M. Attia M. I. and Ezzeldin M. M. (2003) “Energy loss due to sudden contraction through transition length in sloped open channels” Proc. Of 7th Alazhar Engineering International Conference AEIC’ April 7-10 Faculty of Engineering Alazhar University Cairo Egypt.

  • Negm A. M. Elfiky M. M. Attia M. I. and Ezzeldin M. M. (2003) “Protection length downstream of sudden transition for incoming subcritical flow” 1 st International Conference of Civil Engineering Science ICCESI Vol. 1.

  • Nicole R. Nuccitelli and Victor M. Ponce (2014) “The limiting contraction ratio revisited”.

  • Pagliara S. M. Palermo and I. Carnacina (2009) “Scour and hydraulic jump downstream of block ramps in expanding stilling basins” J. Hydraul. Res. 47 4 503–511 DOI: 10.1080/00221686.2009.9522026.

  • Saleh O.K. Negm A. M. Waheed-Eldin O.S. and Ahmad N. G. (2004) “Effect of end sill on scour characteristics downstream of sudden expanding stilling basins” Eighth International Water Technology Conference IWTC8 2004 Alexandria Egypt pp. 601-613.

  • Wu B. and Molinas A. (2005) “Energy losses and threshold conditions for choking in channel contractions” J. Hydraul. Res. 43 139-148.

  • Y. A. Mohamed G. M. Abdel-Aal T. H. Nasr-Allah and A. S. Awad (2013) “Experimental and theoretical investigations of scour at the bridge abutment” J. King Saud Univ. Eng. Sci.

  • Zidan A. R. Owais T. M. and Rashwan I. M. (2009) “Horizontal transitions in subcritical flow” Mansoura Engineering Journal (MEJ) Faculty of Engineering Mansoura University Vol. 15 no.1.

Search
Journal information
Metrics
All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 197 109 3
PDF Downloads 102 69 1