Determination of emissivity coefficient of heat-resistant super alloys and cemented carbide

Open access


This paper presents the analysis of emissivity engineering materials according to temperature. Experiment is concerned on difficult to machine materials, which may be turned with laser assisting. Cylindrical samples made of nickel-based alloys Inconel 625, Inconel 718, Waspaloy and tungsten-carbides based on cobalt matrix were analyzed. The samples’ temperature in contact method was compared to the temperature measured by non-contact pyrometers. Based on this relative, the value of the emissivity coefficient was adjusted to the right indication of pyrometers.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • [1] Joshi A. Kansara N. Das S. Kuppan P. Venkatesan K. A Study of Temperature Distribution for Laser Assisted Machining of Ti-6Al-4V Alloy Procedia Engineering 97 (2014) 1466 - 1473.

  • [2] Kieruj P. Przestacki D. Polycrystalline diamond tool's wear during machining of cemented carbides produced by laser cladding Advances in Manufacturing Science and Technology Vol. 38 No. 4 2014 p.61-70

  • [3] Madura H. Pomiary termowizyjne w praktyce Agenda Wydawnicza PAKu 2004.

  • [4] Anderson M. Patwa R. Shin Y.C. Laser-assisted machining of Inconel 718 with an economic analysis International Journal of Machine Tools & Manufacture 46 (2006) 1879-1891.

  • [5] Przestacki D. Jankowiak M. Surface roughness analysis after laser assisted machining of hard to cut materials. Journal of Physics: Conference Series Volume 483 (2014) 012019 Published online: 28 March 2014

  • [6] Przestacki D. Sieniawski J. Stambolov G. Lisiak P. An overview of selective laser sintering strategies Archives of Mechanical Technology and Automation Vol. 35 2015 s. 1-10

  • [7] Przestacki D. Conventional and laser assisted machining of composite A359/20SiCp Procedia CIRP Vol. 14 2014 pp. 229 - 233

  • [8] Przestacki D. Jankowiak M. Mazur P. Wzorcowanie termometrów bezkontaktowych Zeszyty Naukowe Politechniki Poznańskiej nr 1 2006.

  • [9] Venkatesan K. Ramanujam R. Kuppan P. Parametric modeling and optimization of laser scanning parameters during laser assisted machining of Inconel 718 Optics & Laser Technology 78 (2016) 10-18.

  • [10] Navas V.G. Arriola I. Gonzalo O. Leunda J. Mechanisms involved in the improvement of Inconel 718 machinability by laser assisted machining (LAM) International Journal of Machine Tools & Manufacture 74 (2013) 19-28.

Journal information
Cited By
All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 409 253 10
PDF Downloads 205 133 5