The paper evaluates the drawability of titanium sheet metal Grade 2, with the focus on friction conditions that are present in the sheet metal forming process. The study aims to present the results of the examinations of the friction coefficient during a strip drawing test. The focus of the experiment was on lubricants based on vegetable oils i.e. rapeseed oil, sunflower oil and olive oil. Boric acid was used to improve the lubricating properties of vegetable oils. The results of numerical simulations of the process of forming a cover with stiffening components made of grade 2 titanium sheet metal was also presented. The numerical simulation was carried out using the FEM method with PAMStamp 2G software. The effect of conditions of friction between the sheet metal and tool parts and pressure force of the blank holder on the forming process were investigated. Numerical calculations were performed with consideration for the phenomenon of material strain hardening and anisotropy of plastic properties of the sheet metal formed. The analysis of the deformations and reduction in wall thickness of the drawn parts can be used for determination of the effect of changes in selected parameters on the process of drawn part forming. The quality of drawn parts was assessed based on the shape inaccuracy determined during simulation of forming. The inaccuracy depended on the conditions of the process and strength properties of the titanium sheet metal.