Methods of Research of Foil Bearings in START-STOP Cycle in the Presence of Working Medium

Abstract

A method for testing sliding bearings with an elastic bearing liner was presented in the paper with a focus on the issue of selection of particular time intervals of the START-STOP test cycle. Then, results of the tests carried out according to the selected material combinations were presented. The working cycle of foil bearings tested on the test stand was performed in an automatic mode at the set number of sequences start-work-rundown-stop. Due to the highest use of sliding bearings during start and rundown of a machine, this type of tests is essential for selection of relevant sets of material for bearing elements. The article also presents the use of a thermo-visual camera for identification of additional thermal loads and manners of temperature stabilization in the test chamber.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • Daejong, K., Soongook, P. (2009). Hydrostatic air foil bearings: Analytical and experimental investigation. Tribology International, 42, 413-425.

  • DellaCorte, C. (1998). A new foil air bearing test rig for use to 700°C and 70,000 rpm. Tribology Transactions 41(3), 335-340.

  • Howard, S.A., San Andres, L. (2011). A new analysis tool assessment for rotordynamic modeling of gas foil bearings. Journal of Engineering for Gas Turbines and Power, 133(2), 022505.

  • Kiciński, J., Żywica, G., Miąskowski. W. (2010). The Dynamic Properties of the Micro-Rotor Supported on Fluid-Film Bearings, IFToMM International Conference on Rotor Dynamics, Seoul (South Korea), 681-685

  • Kiciński, J., Żywica, G. (2010). The numerical analysis of the steam microturbine rotor supported on foil bearing, Advances in Vibration Engineering, 11(2), 113-119.

  • Komar, W. (2015). Analiza zużycia cienkiej folii metalowej. Mechanik 7, 417-424.

  • Miąskowski, W., Nalepa, K., Żywica, G. (2009a). Foil micro-bearing tests. Technical Sciences, 12, 249-258

  • Miąskowski, W., Pietkiewicz, P., Żywica. G. (2009b). Modelling foil bearing. Technical Sciences, 12, 241-248.

  • Miąskowski, W., Moczulak, B., Nalepa, K., Pietkiewicz, P., Komar, W. (2017). START-STOP analysis of high-speed bearings with a flexible bushing. SGEM2017 Vienna GREEN Conference Proceedings, 17(63), 69-76.

  • Michalak, M., Michalczewski, R., Piekoszewski, W., Szczerek, M., Wulczyński, J. (2014). Urządzenie do badania odporności na zużycie materiałów przeznaczonych na elementy łożysk foliowych. Tribologia, 3, 131-142.

  • Nalepa, K., Miąskowski, W., Pietkiewicz, P., Miazio, Ł. (2013). Stanowisko do badania łożysk foliowych w cyklu START-STOP w obecności czynnika niskowrzącego. Mechanik, 7, 519-524.

OPEN ACCESS

Journal + Issues

Search