Digital Image Correlation Systems in the Experimental Investigations: Capabilities and Limitations

Abstract

The aim of the paper is to present the possibilities and limitations of using the Digital Image Correlation systems. In order to assess the measurement inaccuracies the measuring volume 1250 × 1100 mm was analysed using two cameras with sensor resolution 6 megapixels. It was stated very good accuracy of the line segment length change. It causes that observation of crack widths can be considered as precisely. Some practical information concern how determine the compatibility between crack width measured traditionally and by using DIC are given. In the second part of the paper the results of the tests concerning capacity of interface between two concrete casting at the same time were presented. Use of the optical measurement system Aramis enables the analysis of the deformation, determination of failure mode of the tested specimens and limit displacement between edges of the interface.

If the inline PDF is not rendering correctly, you can download the PDF file here.

  • 1. Ł. Krawczyk, “Strenthening of short corbels with embedded through-section reinforcement” (in polish) Doctoral Thesis Lodz University of Technology, Poland, 2017.

  • 2. Ł. Krawczyk, M. Goldyn, T. Urban, „About Inaccuracies of DIC System” (in polish) JCEEA: Vol. 64 (3/I/17), 259-270, 2017.

  • 3. M. Gołdyn, Ł. Krawczyk, T. Urban, „Considerations About Carrying Capacity of Elements Subjected to Shear Cutting” (in polish) JCEEA: Vol. 64 (3/I/17), 293-305, 2017,

  • 4. Kneć M., „Technika cyfrowej korelacji obrazów w analizie deformacji połączeń elementów konstrukcji stosowanych w lotnictwie”. Doctoral Thesis. RUT, 2015.

  • 5. D.M. Revilock, J.C. Thesken, T.E. Schmidt, B.S. Forsythe, “Three-Dimensional Digital Image Correlation of a Composite Overwrapped Pressure Vessel During Hydrostatic Pressure Test” Technical Report NASA, 2007.

  • 6. B. Goszczyńska, W. Trąmpczyński , J. Tworzewska, P. Tworzewski, “Doświadczalna analiza odkształceń przestrzennych belek żelbetowych z zastosowaniem skanera optycznego 3D”, Inżynieria i Budownictwo: Vol. 70, No. 3, 156-159, 2014.

  • 7. B. Goszczyńska, J. Tworzewska, “Określenie rysy na potrzeby analizy wyników badania procesu powstawania i rozwoju rys w belkach żelbetowych z zastosowaniem systemu Aramis”, Przegląd Budowlany: Vol. 85, No. 12, 24-29, 2014.

  • 8. N. Randl, M. Wicke, „Schubübertragung zwischen Alt- und Neubeton. Experimentelle Untersuchungen, theoretischer Hintergrund und Bemessungsansatz“, Beton- und Stahlbetonbau: H. 95, 461-473, 2000.

OPEN ACCESS

Journal + Issues

Search