Browse

1 - 10 of 818 items :

  • Functional and Smart Materials x
  • Materials Sciences x
  • Materials Characterization and Properties x
Clear All
Development of sol-gel derived gahnite anti-reflection coating for augmenting the power conversion efficiency of polycrystalline silicon solar cells

Abstract

The present research is focused on developing ZnAl2O4 (gahnite) spinel as an antireflection coating material for enhanced energy conversion of polycrystalline silicon solar cells (PSSC). ZnAl2O4 has been synthesized using dual precursors, namely aluminum nitrate nonahydrate and zinc nitrate hexahydrate in ethanol media. Diethanolamine has been used as a sol stabilizer in sol-gel process for ZnAl2O4 nanosheet fabrication. ZnAl2O4 nanosheet was deposited layer-by-layer (LBL) on PSSC by spin coating method. The effect of ZnAl2O4 coating on the physical, electrical, optical properties and temperature distribution in PSSC was investigated. The synthesized antireflection coating (ARC) material bears gahnite (ZnAl2O4) spinel crystal structure composed of two dimensional (2D) nanosheets. An increase in layer thickness proves the LBL deposition of ARC on the PSSC substrate. The ZnAl2O4 2D nanosheet comprising ARC on the PSSC was tested and it exhibited a maximum of 93 % transmittance, short-circuit photocurrent of 42.364 mA/cm2 and maximum power conversion efficiency (PCE) 23.42 % at a low cell temperature (50.2 °C) for three-layer ARC, while the reference cell exhibited 33.518 mA/cm2, 15.74 % and 59.1 °C, respectively. Based on the results, ZnAl2O4 2D nanosheets have been proven as an appropriate ARC material for increasing the PCE of PSSC.

Open access
SiN/SiO2 passivation stack of n-type silicon surface

Abstract

The SiN/SiO2 stack is widely used to passivate the surface of n-type monocrystalline silicon solar cells. In this work, we have undertaken a study to compare the stack layer obtained with SiO2 grown by both rapid thermal and chemical ways to passivate n-type monocrystalline silicon surface. By varying the plateau time and the plateau temperature of the rapid thermal oxidation, we determined the parameters to grow 10 nm thick oxide. Two-step nitric acid oxidation was used to grow 2 nm thick silicon oxide. Silicon nitride films with three refractive indices were used to produce the SiN/SiO2 stack. Regarding this parameter, the minority carrier lifetime measured by means of QSSPC revealed that the refractive index of 1.9 ensured the best passivation quality of silicon wafer surface. We also found that stacks with nitric acid oxidation showed definitely the best passivation quality. In addition to produce the most efficient passivation, this technique has the lowest thermal budget.

Open access
Deposition time and annealing effects on morphological and optical properties of ZnS thin films prepared by chemical bath deposition

Abstract

Nanocrystalline zinc sulfide thin films were prepared on glass substrates by chemical bath deposition method using aqueous solutions of zinc chloride, thiourea ammonium hydroxide along with non-toxic complexing agent trisodium citrate in alkaline medium at 80 °C. The effect of deposition time and annealing on the properties of ZnS thin films was investigated by X-ray diffraction, scanning electron microscopy, optical transmittance spectroscopy and four-point probe method. The X-ray diffraction analysis showed that the samples exhibited cubic sphalerite structure with preferential orientation along 〈2 0 0〉 direction. Scanning electron microscopy micrographs revealed uniform surface coverage, UV-Vis (300 nm to 800 nm) spectrophotometric measurements showed transparency of the films (transmittance ranging from 69 % to 81 %), with a direct allowed energy band gap in the range of 3.87 eV to 4.03 eV. After thermal annealing at 500 °C for 120 min, the transmittance increased up to 87 %. Moreover, the electrical conductivity of the deposited films increased with increasing of the deposition time from 0.35 × 10−4 Ω·cm−1 to 2.7 × 10−4 Ω·cm−1.

Open access
Green synthesis and spectral analysis of surface encapsulated copper (II) oxide nanostructures

Abstract

Nanostructures of copper (II) oxide were synthesized through chemical reduction of copper (II) sulfate pentahydrate using phytochemicals present in leaf extracts of Leucas aspera. The crystalline phases and size were assessed by X-ray diffraction data analysis. From the Bragg reflection peaks, existence of monoclinic end-centered phase of copper (II) oxide along with presence of cubic primitive phase of copper (I) oxide and traces of cubic face centered lattices of zero valent copper was revealed. The three Raman active modes corresponding to CuO phase were identified in the sample with permissible merging of characteristic bands due to nanostructuring and organic capping. The surface topography measurement using field emission scanning electron microscope evidenced the occurrence of cylindrical rod shaped morphological structures along with a number of unshaped aggregates in the sample. The effective crystallite size and lattice strain were estimated from Williamson-Hall analysis of Bragg reflection data. Tauc plot analysis of UV-Vis-NIR absorption data in direct transition mode provided an estimation of band gap, viz. 1.83 eV and 2.06 eV respectively, for copper (II) oxide and copper (I) oxide. Thermal degradation study using thermogravimetric curve analysis could reveal the amount of moisture content, volatile components as well as the polymer capping over nanorods present in the sample. It could be seen that upon heating, inorganic core crystals undergo oxidation process and at temperature above 464 °C, the sample was found to be composed solely of inorganic crystallite phase of copper (II) oxide.

Open access
Growth, characterization and optical properties of potassium iodide (KI) doped potassium hydrogen phthalate (KHP) single crystals for optoelectronic applications

Abstract

Potassium iodide (KI) doped potassium hydrogen phthalate (KHP) single crystals were grown by slow evaporation technique using millipore water as a solvent. The grown single crystals were analyzed by powder X-ray diffraction and the analysis confirmed that KI-doped KHP crystallizes in orthorhombic system with space group Pca21. The functional groups were identified by FT-IR technique which showed slight shift in vibrational frequencies, indicating inclusion of dopant into the crystal lattice. The UV-Vis spectral studies revealed the optical transparency of the doped crystals in the entire visible region. The optical band gap values were estimated from Tauc plots. Kurtz-Perry powder test was employed for second harmonic generation efficiency studies of the grown crystals.

Open access
Growth, electrical, thermal, mechanical and etching studies on 4-chloroanilinium hydrogen (2R, 3R)-tartrate monohydrate-an organic NLO single crystal

Abstract

An organic single crystal of 4-chloroanilinium hydrogen (2R,3R)-tartrate monohydrate (4CAHT) was grown by slow evaporation solution growth technique at room temperature. Single crystal XRD study confirmed that the crystal belongs to monoclinic system with the space group P21. Powder XRD analysis confirmed the crystalline nature of the compound. The presence of various functional groups in the compound was revealed by FT-IR analysis. UV studies showed the absence of absorption in the entire visible region. To determine the thermal stability of the grown crystals it was subjected to thermogravimetric and differential thermal analyses. Microhardness and etching studies were also carried out for the crystal. The powder second harmonic generation efficiency of 4CAHT was tested by Kurtz and Perry powder technique and the relative SHG efficiency of 4CAHT was found to be 1.44 times greater than that of standard KDP.

Open access
Room temperature ferromagnetic behavior in the nanocrystals of Fe doped ZnO synthesized by soft chemical route

Abstract

In the present study, nanocrystalline undoped and Fe (5 wt.%) doped ZnO powder has been synthesized by soft chemical route. The structural, nano/microstructural, vibrational and magnetic properties of these samples have been studied as a function of calcination temperature (400 °C to 1100 °C). X-ray diffraction analysis of Fe doped ZnO powder has shown the major nanocrystalline wurtzite (ZnO) phase and the minor cubic spinel-like secondary nanocrystalline phase at 700 °C. At calcination temperature of 700 °C, the magnetization and coercivity have been enhanced in Fe doped ZnO. As the calcination temperature increased to 1100 °C, the major phase of ZnO and minor cubic spinel-like secondary phase turned into bulk in doped ZnO. Interestingly, the reduced magnetization and zero coercivity have been observed in this case. These changes are attributed to the conversion of secondary nanocrystalline ferromagnetic spinel phase to its bulk paramagnetic phase. The degree of inversion i.e. the occupancy of both sites with different symmetry by ferric ions is proposed to be solely responsible for the unusual behavior.

Open access
Synthesis of new mesostructured cellular foams (MCFs) with NaY zeolite and their application to sorption of thorium ions

Abstract

The paper presents the new way of preparation of MCF foams with NaY zeolite. Significant changes in the amount of micro and mesopores in relation to the amount of NaY zeolite and 1,3,5-trimethylbenzene (TMB) added during the synthesis was observed. It suggests the possibility of controlling the micro/mesopores ratio by applying the proposed method. Environmental aspects of using new MCF/NaY foams is related to the adsorption of thorium ions (Th+4). The term of “MCF/NaY materials” refers to the general name of the material without referring to the content and state of zeolite. The obtained materials were highly effective in relation to Th+4. The adsorption capacity was greater when the number of micropores was lower. The dependence of adsorption capacity of Th+4 ions on aluminum atoms content was also confirmed.

Open access
Synthesis of single-crystalline Pb(Zr0.52Ti0.48)O3 nanocrystals by hydrothermal method

Abstract

PbZr0.52Ti0.48O3 nanocrystals were synthesized by a hydrothermal method. The effect of NaOH concentration, reaction temperature and time on nucleation and growth of PbZr0.52Ti0.48O3 nanocrystals was investigated. As the 0.05 mol/L PbZr0.52Ti0.48O3 precursors were heated at 200 °C for 21 h with NaOH concentration of 0.5 mol/L, the tetragonal PbZr0.52Ti0.48O3 nanocrystals were formed, and the grain size was more than 20 nm. With increasing the NaOH concentration from 0.5 to 1.5 mol/L, the grain size of PbZr0.52Ti0.48O3 nanocrystals decreased. When the precursors were heated at different temperatures (140 °C to 200 °C) for 21 h with 1.0 mol/L NaOH, single-phase PbZr0.52Ti0.48O3 nanocrystals were obtained at 160 °C to 200 °C. With increasing the reaction temperature from 160 °C to 200 °C, the grains size of PbZr0.52Ti0.48O3 nanocrystals increased from 5 nm to 9 nm. When the precursors were heated at 160 °C in different reaction times from 6 h to 21 h, the evolution from amorphous to crystalline PbZr0.52Ti0.48O3 nanocrystals in correlation with the reaction time was observed. Single crystalline PbZr0.52Ti0.48O3 nanocrystals with narrow size distribution (from 5 nm to 9 nm) were synthesized by controlling the NaOH concentration, reaction temperature and time. The obtained results can find potential application in preparing PbZr0.52Ti0.48O3 thin films on flexible substrates.

Open access
Investigation of the structural, optical and photoluminescence properties of electrosynthesized hexagonal nanocrystalline Cd0.3Zn0.7S thin film

Abstract

In this paper, Cd0.3Zn0.7S thin film has been electrodeposited from aqueous bath containing CdSO4, ZnSO4, Na2S2O3 and EDTA, having pH ~ 14. The structural, optical, morphological, surface wettability and photoluminescence properties of the film were investigated. The XRD pattern showed that the film consisted of mixed phases of CdS and ZnS with polycrystalline structure. The bandgap of the film was evaluated as 2.69 eV. The AFM study revealed that the Cd0.3Zn0.7S thin film contained spherical grains with root mean square roughness of 6.09 nm. The water contact angle measurement showed that the thin film was hydrophilic in nature. Moreover, the PL study revealed that the excitation wavelength was 460 nm.

Open access