Structural Aspects Revealed by SEM Investigations for 2024 Aluminum Alloys

Open access

Abstract

In this presentation are evidenced instrumental characterization by Electronic Scanning Microscopy (SEM) equipped with EDS / WDS of aluminum alloys such 2024 alloy with multiple synergistic purposes as: acquisition of new knowledge, increase the amount of information obtainable about the material, increasing the efficiency and the quality of the tests, characterization of special destination alloys and assessing their conformity with the specified requirements. In this direction, it requires both the knowledge the test methods (theoretical basis, test method, procedure relating to the method, quality assurance testing) as well material characteristics investigated. These aspects are necessary for test system design, and preliminary interpretation of experimental results.

[1] Sadki, M.L.Hattali, M. A. Bradai, R. Youne, N. Mesrati, Characterization and Modeling of the Mechanical Behavior of Aeronautical Alloy Based Composite, Universal Journal of Chemistry 4(1) (2016) 10-19.

[2] P. Rambabu,N Eswara Prasad et all, Aluminium Alloy for Aerospace Application in: Prasad N.E. and Wanhill R.J.H.(Eds.), Aerospace Materials and Material Technologies, Springer Science, Singapore, 2017, pp 29-52.

[3] encea, Bazele incercarilor spectrochimice de emisie optica prin scanteie si arc electric, Ed. Printech, Bucuresti, 2007.

[4] C.I. Crimu, B. Istrate; C. Munteanu, I. Antoniac, M.N. Matei, K. Earar, XRD and Microstructural analyses on biodegradable Mg alloys, Key Engineering Materials, 638, (2015) 79-84.

[5] J.S. Robinson, W. Redington,The influence of alloy composition on residual stresses in heat treated aluminium alloys, Materials Characterization 105 (2015) 47–55.

[6] I.N. Popescu, D. Bojin, I. Carceanu, G. Novac, F.V. Anghelina, Morphological and structural aspects using electronic microscopy and image analysis of iron powders obtained by water atomization process, Journal of Science and Arts 12, Year 10, No. 1(12), pp. 125-134, 2010.

[7] Carmen Otilia Rusanescu, Marin Rusanescu, The stressstrain curves determined for microalloy steel with determined on the torsion tests, Metalurgia, 59 (1) (2007), 38-44.

Journal Information

Metrics

All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 57 57 14
PDF Downloads 36 36 11