Study on Effects of Mold Temperature on the Injection Molded Article

Open access

Abstract

This is a study of the effects of temperature of injection mold on the injection molded article. By supplying water of the proper temperature in the cooling line of mold in the cooling process, the mold was the appropriate temperature, and the deformation of the injection molded article was examined according to the mold temperature. In this study, we conducted simulation analysis and experiments, and the results were analyzed. The minimum deformation of the injection molded article model obtained by supplying 50°C water in the cooling line is 0.003 mm, and the maximum deformation was 0.813 mm. Injection molded article models obtained by supplying 20°C water were found to be a minimum of 0.002 mm, with deformation of up to 0.761 mm. When comparing both conditions, the error rate of injection molded article obtained by supplying 20°C water in the mold cooling line was lower by about 0.18%.

[1] S.H. Kim, S.M. Kim, Journal of the Korean Powder Metallurgy Institute 22 (3), 197 (2015).

[2] J.S. Moon, S.S. Jung, Journal of the Korean Powder Metallurgy Institute 22 (3), 157 (2015).

[4] D.H. Kim, J.W. Lee, Journal of Korea Academia-Industrial cooperation Society 4 (3), 172-173 (2003).

[5] K.Y. Lee, K.Y. Shin, Korean Society of Precision Engineering Conference 6, 497-498 (2011).

Archives of Metallurgy and Materials

The Journal of Institute of Metallurgy and Materials Science and Commitee on Metallurgy of Polish Academy of Sciences

Journal Information


IMPACT FACTOR 2016: 0.571
5-year IMPACT FACTOR: 0.776

CiteScore 2016: 0.85

SCImago Journal Rank (SJR) 2016: 0.347
Source Normalized Impact per Paper (SNIP) 2016: 0.740

Metrics

All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 213 213 10
PDF Downloads 115 115 4