Optimization of Roll Bonding by Hot Rolling in Experimental and Industrial Use

Open access

Abstract

In this study the major topic were the bonding properties of the layer-clad aluminum sheets. The bonding was performed between AlMn1Si0.8 and AlSi10 alloys using hot rolling (a VON ROLL experimental duo mill). The experimental temperatures were 460, 480 and 500°C. The goodness of bonding was tested by tensile test and T-peel test. T-peel test provided a good description about the quality of bonding. Structure analysis was also performed by light microscopy to detect typical bonding faults. The aim of this investigation is modelling the bonding conformation in experimental conditions. Further aim of this investigation is to produce some typical bonding faults and find the cause of formation. The influence of the rolling temperature and surface roughness on the bonding was also analyzed. Rolling schedule and the role of first pass on the development of perfect bonding were experimentally determined.

[1] N. Bay, Cold welding Part I Characteristic bonding mechanisms bond strength, Met. Const. 369 (1986).

[2] M. Eizadjou, H. Danesh Manesh, K. Janghorban, Mechanism of warm and cold roll bonding of aluminum alloy strips, Mat. and Des. 4156 (2009).

[3] W. Zhang, N. Bay, Cold welding-theoretical modeling of weld formation, J. Weld. 417 (1997).

[4] P.K. Wright, D.A. Snow, C.K. Tay, Interfacial conditions and bond strength in cold pressure welding by rolling, Met. Technol. 24 (1978).

[5] H.Y. Wu, S. Lee, J.Y. Wang, Solid state bonding of iron-base alloy, steel-brass and aluminum alloy, J. Mat. Proc. Techn. 173 (1998).

[6] H. Danesh Manesh, A. Karimi Taheri, Study of mechanisms of cold roll welding of aluminum alloy to steel strip, J. Mater. Sci. Technol. 1064 (2004).

[7] H. Danesh Manesh, A. Karimi Taheri, An investigation of deformation behavior and bonding strength of bimetal strip during rolling, Mech. Mater. 531 (2005).

[8] W. Zhang, N. Bay, Cold welding-experimental investigation of the surface preparation methods, J. Weld. 326 (1997).

[9] G. Szabó, V. Mertinger, Technological investigation of plated aluminium sheets, Mater. Sci. F. 729, 482 (2013).

[10] G. Szabó, V. Mertinger, Investigation of typical bonding faults of plated Al sheets developed during rolling, Mater. Sci. F. 812, 387 (2015).

Archives of Metallurgy and Materials

The Journal of Institute of Metallurgy and Materials Science and Commitee on Metallurgy of Polish Academy of Sciences

Journal Information


IMPACT FACTOR 2016: 0.571
5-year IMPACT FACTOR: 0.776

CiteScore 2016: 0.85

SCImago Journal Rank (SJR) 2016: 0.347
Source Normalized Impact per Paper (SNIP) 2016: 0.740

Cited By

Metrics

All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 187 187 26
PDF Downloads 105 105 20