Research on Extruded Products of Mgalzn Alloys – Microstructure and Mechanical Properties / Badania Wyrobów Wyciskanych Ze Stopów Mgalzn – Mikrostruktura I Właściwości Mechaniczne

Open access

The aim of the study was to test and assess products extruded from the magnesium alloys type MgAlZn: AZ31, AZ61 and AZ80A alloys in the form of Ø35mm round bars and 80x15mm flat bars. The test material was extruded in a direct system with the ram feed speed of 1 mm/s and the extrusion ratio λ = 7 ÷ 9. The extruded bars were examined in as-extruded state and after heat treatment to the T5 temper and T6 temper. The strength properties were tested and microstructure was examined with calculation of the average grain size.

[1] Metals Handbook Ninth Edition, Metals Park, Ohio, Properties and Selection Nonferrous Alloys and Pure Metals 2,707-832 (1979).

[2] S. Kleiner a, O. Beffort a, P.J. Uggowitzer, Microstructure evolution during reheating of an extruded Mg-Al-Zn alloy into the semisolid state, Scripta Materialia 51, 405-410 (2004).

[3] E.F Volkova, Met. Sci. Heat. Treat. 48, 508-512 (2006).

[4] T. Rzychoń, J. Szala, A. Kiełbus, Microstructure, castability, microstructural stability and mechanical properties of ZRE1 magnesium alloy, Archives of Metallurgy and Materials 57, 254-252 (2012).

[5] R.Ye. Lapovok, M.R. Bernett, C.H.J. Davies, J.. Mater. Process. Tech. 146, 408-414 (2004).

[6] T. Rzychoń, A. Kiełbus, L. Lityńska-Dobrzyńska, Microstructure, microstructural stability and mechanical properties of sand-cast Mg-4Al-4RE alloy, Materials Characterization 83, 21-34 (2013), doi: 10.1016/j. matchar.2013.06.001 (2013).

[7] ASM Speciality Handbook, Magnesium and Magnesium Alloys, ASM International Materials Park, OH, 2004.

[8] B. Płonka, K. Remsak, M. Nowak, M. Lech-Grega, P. Korczak, A. Najder, Arch. Metall. Mater. 59, 377-383 (2014).

[9] B. Płonka, J. Kut, P. Korczak, M. Lech-Grega, M. Rajda, Arch. Metall. Mater. 57, 619-626 (2012).

[10] B. Płonka, M. Lech-Grega, K.Remsak, P. Korczak, A. Kłyszewski, Arch. Metall. Mater. 58, 127-132 (2013).

Archives of Metallurgy and Materials

The Journal of Institute of Metallurgy and Materials Science and Commitee on Metallurgy of Polish Academy of Sciences

Journal Information

IMPACT FACTOR 2016: 0.571
5-year IMPACT FACTOR: 0.776

CiteScore 2016: 0.85

SCImago Journal Rank (SJR) 2016: 0.347
Source Normalized Impact per Paper (SNIP) 2016: 0.740


All Time Past Year Past 30 Days
Abstract Views 0 0 0
Full Text Views 129 129 10
PDF Downloads 40 40 4