Numerical Analysis of the Forming Process of Head Toothing in Rolling Extrusion on a Shaft from Aluminum Alloy 7075 / Analiza Numeryczna Kształtowania Uzębienia Czołowego W Procesie Przepychania Obrotowego Na Wałku Ze Stopu Aluminium 7075
This paper presents the forming method of head toothing with the application of rolling extrusion technology. Tools numerical models were used in numerical calculations. The presented numerical results concern metals flow kinematics, distributions of stresses and strains. Determined in the process technological parameters of head toothing forming allow foreseeing real material flow in the experiment planned for conducting.
 J. Bartnicki, The theoretical and experimental research of rolling extrusion process, Lublin 2009.
 J. Bartnicki, FEM analysis of hollow hub forming in rolling extrusion process, Metalurgija 53, 641 (2014).
 Z. Pater, Cross - Wedge Rolling, Lublin 2009.
 A. Danno, T. Tanaka, Characteristics of billet deformation in 3-roll wedge rolling of axisymmetric stepped shafts, Kyoto (1984)
 R. Glaβ, F. Hahn, M. Kolbe, L. W. Meyer, Process of partial bulk metal forming - aspects of technology and FEM simulation, Journal of Materials Processing Technology 80-81, 174 (1998).
 J. Tomczak, Z. Pater, T. Bulzak, Designing of screw impressions in the helical rolling of balls, Archives of Civil and Mechanical Engineering 14, 104 (2014).
 Z. Pater, A. Gontarz, W.S. Weroński, The chosen aspects of theory and technology of cross - wedge rolling, Lublin 2001.
 A. Gontarz, A. Dziubińska, Ł. Okoń, Determination of friction coefficient at elevated temperatures for some Al, Mg and Ti alloys. Archives of Metallurgy and Materials 56, 379 (2011).
 J. Bartnicki, J. Tomczak, The tool for rolling extrusion of head toothing P.397944, 2012.
 A. Stefanik, H. Dyja, P. Szota, S. Mróz, Determination of the Critical Value of Normalized Cocroft - Latham Criterion during Multi Slight Rolling Based on Tensile Test, Archives of Metallurgy and Materials 56, 543 (2011).